# Autonomous mode count issue 3.3.1.14612 firmware

**URL:** <https://discuss.blues.com/t/autonomous-mode-count-issue-3-3-1-14612-firmware/860>\
**Category:** Firmware\
**Created:** [June 4, 2022, 8:22pm UTC](https://discuss.blues.com/t/autonomous-mode-count-issue-3-3-1-14612-firmware/860 "2022-06-04T20:22:20Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![Pat](https://sea2.discourse-cdn.com/flex020/user_avatar/discuss.blues.com/pat/32/143_2.png) [@Pat](https://discuss.blues.com/u/Pat)\
**Post date:** [June 4, 2022, 8:22pm UTC](https://discuss.blues.com/t/autonomous-mode-count-issue-3-3-1-14612-firmware/860/1 "2022-06-04T20:22:20Z")

</div>

Using {“req”:“card.aux”,“mode”:“gpio”,“usage”:[“count”,“count”,“count”,“count”],“sync”:true,“file”:“statechange.qo”}

With external pullup 47k resistor on each Aux1,2,3,4

Only Aux3 counts in single increments. The other Aux Pins 1,2,4 count wildly. Jumping 50-100 or more counts when pulling the pins low momentarily.  
Any thoughts on this.

Also a question…  
When Using “input-pullup” or “input” for “usage” in mode “gpio” does it take a level change of 1 sec or more to catch the change?

Thanks for your help.