Gps: unable to refresh after 90 sec (no signal)

Hardware Notecarrier A
1

Hi I’m using a notecarrier A w/ built in antennas. I have the board outside on a table full view to sky but I get this message : “text”: “gps: unable to refresh after 90 sec (no signal)”

No host MCU, I have the card location setup as periodic w/ 600 seconds. The card also will sync every 15 minutes.

I moved the unit ( to cause a gps update ) but I only see these timeouts, although it did sync to gps once yesterday.

Just updated firmware to 6.2.5.16868 with no improvement.

Thoughts!???

2

Hi @gomario2,

Please first consult our brief guide on diagnosing GPS issues. There are a lot of common issues addressed here. Happy to follow up once you’ve had a chance to run through that doc.

Thanks,
Rob