Running a Swan, my Win10 computer does not see a serial port when I plug into the Swan’s built-in USB micro. I have confirmed that the option bytes are set properly using STM32CubeProgrammer and the STM32 CLI. When I run Zadig, I do see a port “STM32 Bootloader”, I’m not an ace at using Zadig but th…

Hi @occamman , I always recommend using an STLINK debugger when working with any STM32-based host. It’s just far and away the best experience. If that isn’t an option, did you upgrade the WinUSB driver with Zadig (wasn’t quite clear in your text if you followed through or not). And of course reboot…

Thanks Rob. Agree on STLink! I use it during development, but need a USB/Serial port for shipping product. I tried upgrading the driver. Even rebooting :slight_smile:. Still no USB port. In Windows Device Manager, I do see “STM32 BOOLOADER”.

Hi @occamman , Under which category in the device manager do you see “STM32 BOOTLOADER”? For example, on Windows 11 with just a Swan (no STLINK) in its bootloader, I see this: [image]

Under my Win10 computer with STLINK disconnected, it shows up under Universal Serial Bus Devices as STM32 BOOTLOADER. I just tried this out on my Win11 computer and I don’t see anything in Device Manager.

Working off of a hunch here. I would try installing STM32CubeCLT and see if that helps. Gotta love the STM32 tool chain! Rob

I apologize if I’m being obtuse – what should I do with the STM32CubeCLT once installed?

Nothing actually - it installs some proprietary software from ST that, in many cases, resolves these types of issues on Windows.

OK. I installed, re-booted, no improvement.

Hi @occamman , A colleague pointing out something to me that I may have missed early on. If you do see “STM32 BOOTLOADER” in device manager, then your Swan is already in its bootloader and ready to receive updated firmware. If you want to reset the board you can press the white RST button.

OK, I’ve had a chance to follow up on this… I’m still unable to see the Swan USB as a serial port from my PC. The STM32 BOOTLOADER device only shows up when I do the Boot/Reset combo. I’ve now tried this on two different computers, one with Win10 and one with Win11, and using two Swan units. AFAI…

Swan USB/Serial not showing up on Win/10

Hardware

RobLauer August 30, 2024, 9:16pm 16

I was just reminded of this thread, where installing STM32 Cube IDE along with Cube Programmer resolved the issue on Windows. Worth a shot!

Topic		Replies	Views
No USB on my Swan Hardware	2	237	November 17, 2023
Swan USB Uploads Not Working (Windows 11, Arduino IDE) Firmware	2	206	April 6, 2024
Cannot communicate with Swan over USB Hardware	2	1166	April 16, 2025
Problem Uploading to my Swan MCU using PlatformIO Hardware	15	756	August 30, 2024
Can't connect debug adapter to Swan Firmware	1	199	December 4, 2023

Swan USB/Serial not showing up on Win/10

Related topics