Strain senor data (three pin) via qwiik connector (4 pin)

Hardware Notecarrier F
1

Please advise with any solution.

I was wanting to incorporate this module.

(Taidacent Strain Gauge 350 Ohm Bend Flex Sensor Weighing Amplifier Module)

  • Pin Config for Sensor - GND, VCC, & OUT from sensor. (Three pin for sensor.)

into my notecarrier F, for data collection. Can this work with the three pin setup off of the sensor to the 4 pin notecarrier Qwiik connector? Endgoal, to view events of data via notehub.

I have attached photos of the module with the strain sensor installed below for reference.

IMG_3098.HEIC
IMG_3098.HEIC3024×4032 1.63 MB

Thank you.

2

Hey @Lucky,

Welcome to the Blues community!

Can this work with the three pin setup off of the sensor to the 4 pin notecarrier Qwiik connector?

No, the OUT from the module is an analog output which would have to connect to one of the F_A0-5 pins. Qwiic is I2C only.

TJ

3

Great. Thank you TJ.